bio-tank lock2

JAPAN QUALITY

Secure your diving tank in seconds with very little effort and up to 10X more tightening torque than any conventional tank buckle.

Adjustable screw system makes installation and removal from tank a breeze.
Heavy duty spring automatically adjusts as webbing contacts to keep your tank in place and stable.
Adapts to most B.C.D’s and tank sizes.

Hold the tank at the maximum tension of more than 100kg.

Normal tank belt would lengthen when it gets wet in the water, this often leads the trouble of tank displacement at the time of traveling on the surface of water and or getting out of water.
The " bio- tank lock pro" will maintain the maximum tension of 100kg or higher in holding the tank with assist of the built-in spring. For this reason, even when the belt gets wet with water, the built-in spring will absorb the belt lengthening, thus it will not cause the tank displacement.

Installation method How to set the bio-tank lock 2

Step1: After puts on the tank, hold the knob #2 and then pull end of the belt toward direction of #1.

Step2: Push down the lock lever #3 with keeping the end of belts #1.

Step3: Turn the knob #4, check the spring that has fully pressed and then the space of the body of buckles are about 10 to 15mm.

Step4: Put the end of belt into the belt holder #5, and check that the buckles can not be moved by hands, then setting is completely finished.

Spec

Material of the main body

Aluminum die casting

Material of the screws

SUS304

Material of the knob

POM

Belt length

900mm

Belt width

50mm

Weight

330g

NSN

4220-66-152-0152